67
PERIODIC SERVICE
ENGLISH
B
Replacing Transmission Oil Filter [HST]
To avoid personal injury:
A
Be sure to stop the engine and remove the key
before changing the oil filter.
A
Allow transmission case to cool down
sufficiently; oil can be hot and may cause
burns.
1. The oil filter must be changed every 200 service hours.
2. Place an oil pan underneath the oil filter. (Do not drain
oil.)
3. Remove the oil filter by using the filter wrench.
4. Apply a slight coat of oil onto the gasket of new filter.
5. Tighten the filter quickly until it contacts the mounting
surface. Tighten filter by hand an additional 1/2 turn
only.
6. After the new filter has been replaced, the
transmission fluid level normally lowers a little. Add
fluid to proper level. Check for oil leaks around filter
gasket.
A
To prevent serious damage or premature failure to the
hydraulic system, use only a KUBOTA genuine filter.
B
Adjusting the Motion Control Lever Pivot
To avoid personal injury:
A
Be sure to stop the engine and set the parking
brake to "ON" before checking.
1. Set the motion control lever in "NEUTRAL" position.
2. Slightly move the lever back and forth and measure
the free travel at the top of lever stroke.
3. If the proper free travel limits are exceeded, remove
the fender and retighten only the upper nut to specified
torque.
A
If the motion control lever pivot bolt is maladjusted,
motion control may be difficult.
(1) Transmission oil filter [HST]
(1) Transmission oil filter [HST] (2) Gasket
Proper lever free travel
2 to 15 mm (0.08 to 0.59 in.)
on the lever
(1) Motion control lever
(2) Bolt, Nut
(A) "FREE TRAVEL"
Tightening torque
18.6 to 20.6 N-m
(1.9 to 2.1 kgf-m,
13.7 to 15.2 lbf-ft)
Summary of Contents for ZG332
