Kubota ZG222A, Operator'S Manual

Page: 74 / 111

PERIODIC SERVICE 54
ENGLISH
8. Remove large debris around the cooling fin and then
blow off small debris with a compressed air. Pressure
of compressed air must be under 205 kPa (2.1 kgf/
cm , 30 psi).
9. Blow off the debris inside the fan cover as shown in the
figure. Pressure of compressed air must be under 205
kPa (2.1 kgf/cm , 30 psi).
10.Undo the rubber hook and open the air intake screen.
Remove the debris on the surface of the air intake area
by hand and blow off small debris with compressed air.
Pressure of compressed air must be under 205 kPa
(2.1 kgf/cm , 30 psi).
Then clean them completely by pushing down the
bottom clean lever several times.
When using the bottom clean lever, remove the lever
from the bracket.
After cleaning, make sure that the lever is replaced in
place.
11.Install the cover with six bolts and then the fan cover
with two screws.
12.Install the muffler cover with four bolts.
13.Pull up the seat support rod and release the "LOCK".
14.Lower the seat slowly to lock.
15.Close the hood.
(1) Cover
(2) M6 bolt
(3) M8 bolt
(1) Cover
(2) M6 bolt
(1) Cooling fin
(1) Fan cover
(1) Air intake screen
(2) Engine dust plate
(3) Dust cover
(4) Bottom clean lever (A) "PUSH DOWN"
(B) Bracket