Kubota WSM M8540, Workshop Manual, Page: 40 / 41

G-18
M8540, M9540, WSM G GENERAL
[2] CHECK POINTS OF INITIAL 50 HOURS
Adjusting Clutch Pedal (Synchro Shuttle Model)
1. Stop the engine and remove the key.
2. Slightly depress the clutch pedal and measure free travel at the
top of pedal stroke.
3. [ROPS model]
If adjustment is needed, loosen the lock nut (1) and turn the
turnbuckle (2) to adjust the rod length within acceptable limits.
[CABIN model]
If adjustment is needed, loosen the lock nut (1) and to adjust the
cable length within acceptable limits.
4. Retighten the lock nut (1).
W1066699
Changing Engine Oil
CAUTION
• Before changing oil, be sure to stop the engine.
• Allow engine to cool down sufficiently, oil can be hot and
can burn.
1. To drain the used oil, remove the drain plugs (2) at the bottom of
the engine and drain the oil completely into the oil pan.
All the used oil can be drained out easily when the engine is still
warm.
2. After draining reinstall the drain plugs (2).
3. Fill with the new oil up to the upper notch on the dipstick.
(Refer to “4. LUBRICANTS, FUEL AND COOLANT” in this
section.)
W1021565
Proper clutch pedal free
travel (
L )
Factory spec.
40 to 50 mm
1.6 to 2.0 in.
(1) Lock Nut
(2) Turnbuckle
(3) Cable L : Free Travel
[A] ROPS Model
[B] CABIN Model
Oil capacity with filter
10.7 L
11.3 U.S.qts
9.4 Imp.qts
(1) Oil Inlet
(2) Drain Plugs (A) Oil level is acceptable within this
range.
KiSC issued 03, 2009 A