S-52
V3300-E2B, V3300-T-E2B, WSM
DIESEL ENGINE
Flywheel Housing
1. Remove the flywheel housing.
(When reassembling)
• Tighten the flywheel housing mounting screws with even force on
the diagonal line.
• Make sure the crank cases 1 and 2 are clean. Install them in
position, referring to the flywheel housing’s contoured face.
W1060705
Crankcase 2
1. Remove the crankcase 2 (1).
(When reassembling)
IMPORTANT
■
• Make sure the crankcase 1 and 2 are clean.
• Apply liquid gasket (Three Bond 1217D) to the crankcase 2
as shown in the figure.
• Tighten the crankcase 2 mounting screws with even force on
the diagonal line.
• Confirm that the liquid gasket coating surface is free of
water, dust and oil in order to maintain sealing effect.
• Carefully apply the adhesive evenly.
NOTE
■
• When mounting the adhesive-applied parts, take care to fit
them to the mating parts.
• Assemble the adhesive-applied parts within ten minutes.
W1060825
Crankcase 1 and Crankcase 2
(When reassembling)
• Match the crankcase 1 and 2, referring to the flywheel housing’s
contoured face.
• Tighten the crankcase 2 mounting screws loosely.
• Tighten up the jig to the specified torque same as the flywheel
housing screw. This helps to minimize the level difference
between the crankcase 1 and the crankcase 2 (at the flywheel
side). Possible gap must be 0.05 mm (0.0020 in.) or smaller.
W1111351
Tightening torque
Flywheel housing
mounting screw
77.5 to 90.2 N·m
7.9 to 9.2 kgf·m
57.1 to 66.5 ft-lbs
(1) Flywheel Housing
Tightening torque
Crankcase 2 mounting
screw
49.0 to 55.9 N·m
5.0 to 5.7 kgf·m
36.2 to 41.2 ft-lbs
(1) Crankcase 2
(2) Liquid Gasket
Tightening torque
Crankcase 2 mounting
screw
49.0 to 55.9 N·m
5.0 to 5.7 kgf·m
36.2 to 41.2 ft-lbs
Flywheel housing
mounting screw
77.5 to 90.2 N·m
7.9 to 9.2 kgf·m
57.1 to 66.5 ft-lbs
(1) Crankcase 1
(2) Gap to be smaller than 0.05 mm
(0.0020 in.)
(3) Flywheel Housing
(4) Crankcase 2
(5) Jig
KiSC issued 06, 2006 A
