Kubota M7040SU, Operator'S Manual

Page: 51 / 90

33 THREE-POINT HITCH & DRAWBAR
3-POINT HITCH
B
Category 1 & 2
The standard tractor has both category 1 & 2.
Category 1 type is standard and assemble all parts shown
as below.
To change from category 1 to category 2.
1. Remove adjusting collar from the lower link.
2. Add side collar onto both the lower links.
3. Remove adjusting collar from the rear top link pin.
4. Use the correct rear top link pin for category 2.
B
Selecting the holes of Lower Links
There are two holes in the lower links. For most
operations the lifting rods should be attached to the (B)
hole.
A The lifting rods may be attached to (A) for greater
lifting force.
B Selecting the Top Link Mounting Holes
Select the proper set of holes by referring to the
"Hydraulic Control Unit Use Reference Chart" in
"HYDRAULIC UNIT" section.
B
Drawbar
Remove the drawbar if a close mounted implement is
attached.
1 . Make preparations for attaching
implement.
(1) Lower link
(2) Top link
(3) Collar, lower link (1)
(4) Top link rear pin (1) (5) Collar, top link (1)
(6) Top link rear pin (2)
(7) Collar, side (2)
(1) Lower link
(2) Lifting rod holes: (A), (B)
(1) Top link
(2) Mounting hole
(3) Handle