15. Checking headlight, turn signal
light, hazard light, and so on
1. Inspect the lights for broken bulbs and lenses.
2. Replace if broken.
16. Checking seat belt and ROPS
1. Always check the condition of the seat belt
attaching hardware and ROPS before operating the
tractor.
2. Replace if damaged.
17. Checking movable parts
If any of the movable parts, such as levers and pedals,
are not moving smoothly because of rust or sticky
material, do not attempt to force them into motion.
In the above case, remove the rust or the sticky
material and apply oil or grease to the relevant spot.
Otherwise, the machine may be damaged.
INITIAL 50 HOURS
With a new machine, be sure to do the following
servicing after the first 50 operating hours.
1. Changing engine oil
(See Changing engine oil on page 165.)
2. Replacing engine oil filter
(See Replacing engine oil filter on page 166.)
EVERY 50 HOURS
1. Checking engine start system
WARNING
To avoid personal injury or death:
• Do not allow anyone near the tractor while
testing.
• If the tractor does not pass the test, do not
operate the tractor.
(1) Main gear shift lever
(2) Clutch pedal
(3) PTO clutch control lever
1.1 Preparation before testing
1. Place all control levers in the
“NEUTRAL”
position.
2. Set the parking brake, stop the engine and lower all
implements.
1.2 Testing switch for the main gear shift
lever
1. Follow the
“PARKING THE TRACTOR”
instructions.
(See PARKING THE TRACTOR on page 13.)
2. Sit on the operator's seat.
3. Shift the main gear shift lever to the desired
position.
4. Depress the clutch pedal fully.
5. Disengage the PTO clutch control switch or lever.
6. Turn the key to
“START”
position.
7. The engine must not crank.
8. If it cranks, consult your local KUBOTA Dealer for
this service.
1.3 Testing switch for PTO clutch control
switch or lever
1. Follow the
“PARKING THE TRACTOR”
instructions.
(See PARKING THE TRACTOR on page 13.)
2. Sit on the operator's seat.
3. Engage the PTO clutch control switch or lever.
4. Depress the clutch pedal fully.
5. Shift the main gear shift lever to the
“NEUTRAL”
position.
6. Turn the key to
“START”
position.
7. The engine must not crank.
8. If it cranks, consult your local KUBOTA Dealer for
this service.
PERIODIC SERVICE
DAILY CHECK
154
M6S-111,M6L-111,M6H-101
Summary of Contents for M6H-101
