3-POINT HITCH SETUP
1. Make preparations for attaching implement.
• Selecting the holes of lower links on page 106
• Adjusting lateral float on page 106
• Selecting the top link mounting holes on page
• Draft stopper on page 107
• Drawbar on page 107
2. Attaching and detaching implements
WARNING
To avoid personal injury or death:
• Be sure to stop the engine.
• Do not stand between tractor and implement
unless the parking brake is applied.
• Before
attaching
or
detaching
the
implement, locate the tractor and implement
on a firm level surface.
• Whenever an implement or other attachment
is connected to the tractor 3-point hitch,
check
full
range
of
operation
for
interference, binding or PTO separation.
• Do not exceed the maximum allowable
length of either lifting rod, or the lifting rod
will come apart and the 3-point equipment
may fall.
• Lifting rod (left) on page 107
• Lifting rod (right) on page 107
• Top link on page 108
• Telescopic stabilizers on page 108
• Telescopic lower links on page 108
1. Selecting the holes of lower links
There are 2 holes in the lower links. For most
operations, the lifting rods should be attached to the (B)
hole.
(1) Lower link
(2) Lifting rod
(A) Hole
(B) Hole
NOTE :
• The lifting rods may be attached to (A) hole for
greater lifting height.
2. Adjusting lateral float
To allow the implement to follow the shape of the
ground, attach the rectangular washers and pin heads
in vertical position.
To hold the implement, reset the rectangular washers
and pin heads in horizontal position.
(1) Rectangular washer
(2) Pin head
(A) Horizontal position
(B) Vertical position
Floating mechanism
When the floating mechanism is used, the implement is
able to follow the tractor freely in response to the soil
and ground conditions. This is suited for operation with
implements wider than the tractor.
3. Selecting the top link mounting
holes
Select the proper set of holes.
(See Hydraulic control unit use-reference chart on page
115.)
If the hydraulic unit is set for draft control, draft
response is more sensitive when an implement is
connected to the lower set of top link mounting holes. If
draft control is not required, it is recommended to use
the top set (1).
3-POINT HITCH AND DRAWBAR
3-POINT HITCH SETUP
106
M6S-111,M6L-111,M6H-101
Summary of Contents for M6H-101
