Kubota M5660SUH, Operator'S Manual

Page: 100 / 117

PERIODIC SERVICE 78
6. Tighten the filter quickly until it contacts the mounting
surface.
Tighten filter by hand an additional 1/2 turn only.
7. After the new filters have been replaced, fill the
transmission oil up to the upper notch on the dipstick.
8. After running the engine for a few minutes, stop the
engine and check the oil level again, add oil to the
prescribed level.
9. Make sure that the transmission fluid doesn't leak pass
the seal on the filters.
A
To prevent serious damage to the hydraulic system,
use only a KUBOTA genuine filter.
A
Do not operate the tractor immediately after changing
the transmission fluid.
Run the engine at medium speed for a few minutes to
prevent damage to the transmission.
B
Replacing Fuel Filter
To avoid personal injury or death:
A
Be sure to stop the engine before replacing the
fuel filter.
1. Remove the fuel filter.
2. Put a film of clean fuel on rubber seal of new filter.
3. Tighten the filter quickly until it contacts the mounting
surface.
Tighten filter by hand an additional 1/2 turn only.
4. Bleed the fuel system.
(See "Bleeding Fuel System" in "SERVICE AS
REQUIRED" in "PERIODIC SERVICE" section.)
(1) Dipstick
(2) Oil inlet (A) Oil level is acceptable within this range
(1) Fuel filter