PTO
42
B
PTO Gear Shift Lever
[if equipped]
To avoid personal injury or death:
A
Be sure to observe the PTO shaft speed
prescribed for the individual implements. It is
extremely dangerous to run an implement at
high speed that is meant to be operated at low
speed. Use only when this higher rpm is
specifically recommended by the implement
manufacturer.
The PTO gear shift lever can be set to either 540 rpm or
540E rpm positions.
Move this lever to either position with the PTO clutch
control switch set to "OFF".
A
When light load, select the "540E" position for
economical operation.
B
PTO Speed Limiter
A
Move the PTO gear shift lever (if equipped) to "540E"
and then set the PTO clutch control lever to the "ON"
position, and the rev-limiter indicator lights up on the
meter panel.
A
If set the PTO clutch control lever to the "ON" position
with the engine rpm higher than the PTO 540E limit
level, the PTO clutch indicator on the meter panel
starts blinking and the PTO is disabled. After a while,
the engine rpm automatically drops below the PTO
540E limit level and the PTO starts functioning. At the
same time, the flashing PTO clutch indicator stays
"ON".
A
If set the PTO clutch control lever to the "OFF" position
but the engine rpm fails to rise with the throttle, return
the engine rpm to a lower level. This enables
acceleration again.
(1) PTO gear shift lever
(A) 540 rpm
(B) 540E rpm
PTO gear
shift lever
Engine speed
rpm
PTO speed
rpm
540
2160
540
540E
1828
540
(1) Rev-limiter indicator
(2) PTO clutch indicator
PTO
Limitation PTO / Engine speed (rpm)
540E
630 / 2132
Summary of Contents for M5660SUH
