Kubota LD1607, Manual

Page: 18 / 28

8
(1) Loader Hydraulic Control Lever (A) Close
(B) Open
For non Kubota Loaders, please refer to the loader
operator’s manual for 3
rd
function / 4in1 operation.
CAUTION:
To avoid personal injury:

Valve lock does not lock out switch operated
third-function hydraulics.
FRONT REMOTE HYDRAULIC
CONTROL SYSTEM
This system is fitted as an option on Kubota loaders, and
is required for front mounted hydraulic implement such as
the 4in1 bucket. It provides hydraulic oil to the front outlet
directly.

Install the Coupler
1. Remove the cap from the front hydraulic outlet.
2. Install the hydraulic quick coupler as required.
(1) Front Hydraulic outlet
(2) Hydraulic quick coupler (included in this kit)

Remote Control Coupler Connecting and
Disconnecting
CAUTION:
To avoid personal injury:

Stop the engine and relieve pressure before
connecting or disconnecting lines.

Do not use your hand to check for leaks.

Relieve Hydraulic Pressure
1. Move the key switch to
the “RUN” position.
NOTE:

Don’t start the engine.
2.
Press the activation switch A and B several times to
relieve hydraulic pressure.
3.
Turn the key switch to the “OFF” position.

Connecting
1. Clean both couplers.
2. Remove dust plugs.
3. Insert the implement couplers to the tractor hydraulic
couplers.
4. Pull the implement coupler slightly to make sure
couplers are firmly connected.

Disconnecting
1. Lower the implement to the ground to release
hydraulic pressure in the hoses.
2. Shut the engine down.
3.
Move the key to the “RUN” position.
NOTE:

Don’t start the engine.
4.
Press the activation switch A and B several times to
relieve hydraulic pressure.
5.
Turn the key switch to the “OFF” position.
6. Clean the couplers before disconnecting.
7. Pull the hose straight from the hydraulic coupler to
release it.
8. Clean oil and dust from the coupler, then replace the
dust caps and plugs.
NOTE:

Your local KUBOTA dealer can supply parts to adapt
couplers to hydraulic hoses
.