＿
11
＿
5. Hold the Handheld Blower with your left
hand and press it down firmly. Hold the
assist handle with your right foot gently.
IMPORTANT: Be careful not make dam-
ages to fuel tank or the blower by your
foot.
6. Pull the starter grip. Grasping the starter
grip, slowly pull the starter cord out until
you feel resistance, then pull the cord
quickly and powerfully. Pull the starter
grip until the engine starts.
7. After the engine starts, move the throttle setting lever to the idle position, then move the choke
lever to the open ( ) position.
If the engine stops running before you move the choke lever to the open ( )
position:
A. Go ahead and open the choke.
B. Make sure the throttle setting lever is set to the idle position.
C. Pull the starter grip until the engine starts.
HOT RESTART
To start the engine that is already warmed up (hot restart), or if the ambient temperature exceeds
20°C:
1. Pump the primer bulb at the bottom of the carburetor until fuel can be seen flowing through the
fuel return line to the fuel tank.
2. Move the choke lever to the open ( ) position and move the stop switch to the “ON”
position.
3. More the throttle setting lever to the idle position and pull the starter grip.
4. If the engine fails to start after three to four pulls, follow the instruction in the Cold Starting
Procedure section (page10).
If the engine fails to start after you follow the above procedures, contact an authorized KUBOTA
dealer.
NOTE: 1. Don't pull the starter cord out completely.
2. Do not release the starter cord from the fully extended position.
TO STOP THE ENGINE
1. Move the throttle setting lever to the idle position. Release the throttle trigger.
2. Slide the stop switch to the “STOP” position.
Fuel TANK
Assist Handle