Kubota CKTGL11000, Operator'S Manual, Page: 47 / 62

35 PERIODIC SERVICE
ENGL
ISH
When battery boost starting engine, follow the instruc-
tions below to safely start the engine.
1. Bring helper battery of the same voltage as disabled
generator within easy cable reach.
2. Put on safety goggles and rubber gloves.
3. Ensure the vent caps are securely in place. (if
equipped)
4. Cover vent caps with damp rags. Do not allow the
rag to touch the battery terminals.
5. Attach the red clamp to the positive (red, or pos.)
terminal of the dead battery and clamp the other end
of the same cable to the positive (red, or pos.)
terminal of the helper battery.
6. Clamp the other cable to the negative (black, or
neg.) terminal of the helper battery.
7. Clamp the other end to the engine block or frame of
the generator as far from the dead battery as
possible.
8. Start the disabled generator.
9. Disconnect the jumper cables in the exact reverse
order of attachment. (Steps 7, 6 and 5).
10.Remove and discard the damp rags.
A
This machine has a 12 volt negative ground
starting system.
A
Use only same voltage for jump starting.
A
Use of a higher voltage source on generators
electrical system could result in severe damage to
generators electrical system.
B Electric Wiring
CAUTION
To avoid personal injury:
Shorting of electric cable or wiring may
cause a fire.
A
Check to see if electric cables and
wiring are swollen, hardened or
cracked.
A
Keep dust and water away from all
power connections.
Loose wiring and terminal parts
make bad connections, be sure to
repair them before starting the
engine.
Damaged wiring reduces the capacity of electrical parts.
Change or repair damaged wiring immediately.
B Fuse
The electrical system is protected from potential dam-
age by fuses.
A blown fuse indicates that there is an overload or a
short circuit somewhere in the electrical system.
If any of the fuses should blow, replace with a new one
of the same capacity.
A Before replacing a blown fuse, determine why the
fuse blew and make any necessary repairs. Failure
to follow this procedure may result in serious
damage to the generator electrical system. Refer to
the troubleshooting section of this manual or your
local KUBOTA Dealer for specific information.
(1) Dead battery
(2) Lay a damp rag over vent
caps.
(3) Jumper cables
(4) Engine block or frame
(5) Helper battery
(A) Connect cables in
numerical order.
Disconnect in reverse
order after use.
(A) Fuse box