Kubota BX1870, Operator'S Manual

Page: 84 / 93

PERIODIC SERVICE 66
B
Changing Front Axle Case Oil
1. Park the machine on a firm, flat and level surface.
2. To drain the used oil, remove the right and left drain
plugs and oil gauge at the front axle case and drain the
oil completely into the oil pan.
3. After draining reinstall the drain plugs.
4. Remove the right and left breather plugs.
5. Fill with new oil up to the upper notch on the dipstick.
(See "LUBRICANTS" in "MAINTENANCE" section.)
A
After ten minutes, check the oil level again; add oil to
prescribed level.
6. After filling, reinstall the oil gauge and breather plugs.
EVERY 500 HOURS
B Replacing Fuel Filter Element
Consult your local KUBOTA Dealer for this service.
EVERY 800 HOURS
B
Adjusting Engine Valve Clearance
Consult your local KUBOTA Dealer for this service.
EVERY 1500 HOURS
B
Checking Fuel Injection Nozzle Injection
Pressure
Consult your local KUBOTA Dealer for this service.
EVERY 3000 HOURS
B
Checking Injection Pump
Consult your local KUBOTA Dealer for this service.
EVERY 1 YEAR
B
Replacing Air Cleaner Element
(See "Cleaning Air Cleaner Element" in "EVERY 100
HOURS" in "PERIODIC SERVICE" section.)
EVERY 2 YEARS
B
Flushing Cooling System and Changing
Coolant
To avoid personal injury:
A
Do not remove radiator cap while coolant is
hot. When cool, slowly rotate cap to the first
stop and allow sufficient time for excess
pressure to escape before removing the cap
completely.
1. Stop the engine and let cool down.
2. To drain the coolant, open the radiator drain plug and
remove radiator cap. The radiator cap must be
removed to completely drain the coolant.
3. After all coolant is drained, close the drain plug.
4. Fill with clean soft water and cooling system cleaner.
5. Follow directions of the cleaner instruction.
6. After flushing, fill with clean soft water and anti-freeze
until the coolant level is just below the radiator cap.
Install the radiator cap securely.
7. Fill with coolant up to the "H" mark on the recovery
tank.
8. Start and operate the engine for few minutes.
9. Stop the engine and let cool.
10. Check coolant level of recovery tank and add coolant
if necessary.
Oil capacity
BX1870D 2.3 L (2.4 U.S.qts.)
BX2370D
BX2670D
4.7 L (5.0 U.S.qts.)
(1) Breather plug
(2) Oil gauge with dipstick
(3) Drain plug (A) Oil level is acceptable
within this range
Coolant capacity
(with recovery tank)
BX1870D 2.9 L (3.06 U.S.qts.)
BX2370D 3.1 L (3.3 U.S.qts.)
BX2670D 3.3 L (3.5 U.S.qts.)