Kubota B3300SU, Operator'S Manual

Page: 38 / 79

OPERATING THE TRACTOR 22
A
For checking and servicing of your tractor, consult
your local KUBOTA Dealer for instructions.
B
Fuel Gauge
When the key switch is on, the fuel gauge indicates the
fuel level.
Be careful not to run the fuel tank dry. Otherwise air may
enter the fuel system.
Should this happen, the system should be bled. (See
"Bleeding Fuel System" in "SERVICE AS REQUIRED" in
"PERIODIC SERVICE" section.)
B
Coolant Temperature Gauge
To avoid personal injury:
A
Do not remove radiator cap until coolant
temperature is well below its boiling point.
Then loosen cap slightly to the stop to relieve
any pressure before removing cap completely.
1. With the key switch at "ON", this gauge indicates the
temperature of the coolant. "C" for "cold" and "H" for
"hot".
2. If the indicator reaches the "H" position (red zone),
engine coolant is overheated. Check the tractor by
referring to "TROUBLESHOOTING" section.
B
Hourmeter / Tachometer
This meter gives readings for engine speed, PTO shaft
speed and the hours the tractor has been operated.
1. The tachometer indicates the engine speed and the
540 PTO shaft speed location on the dial.
2. The hourmeter indicates in five digits the hours the
tractor has been used; the last digit indicates 1/10 of
an hour.
Electrical charge
If the alternator is not charging the battery, the
warning lamp in the Easy Checker(TM) will come
on.
If this should happen during operation, check the
electrical charging system or consult your local
KUBOTA Dealer.
(1) Fuel gauge (A) "EMPTY"
(B) "FULL"
(1) Coolant temperature gauge
(1) Engine revolution
(2) Hours used (A) PTO: 540 rpm