Kubota B2401DT, Operator'S Manual

Page: 81 / 95

5. Properly dispose of used oil.
(1) Engine oil filter
IMPORTANT :
• To prevent serious damage to the engine,
use only a KUBOTA genuine filter.
• When replacing the engine oil filter:
– Be careful not to allow any oil onto the
harness.
– Use an oil pan or the like, which could
allow no oil to flow into the wire harness.
2. Changing engine oil
WARNING
To avoid personal injury or death:
• Be sure to stop the engine and remove the key
before changing the oil.
• Allow engine to cool down sufficiently, oil can
be hot and can burn.
1. To drain the used oil, remove the drain plug at the
bottom of the engine and drain the oil completely
into the oil pan.
2. After draining reinstall the drain plug.
3. Fill with the new oil up to the upper notch on the
dipstick.
(See LUBRICANTS, FUEL AND COOLANT on
page 59)
NOTE :
• In adding engine oil, use a funnel or the like.
4. Properly dispose of used oil.
Oil capacity with filter 3.1 L (0.8 U.S.gals.)
(1) Oil inlet
(1) Dipstick (A) Range which engine oil level
is acceptable within
(1) Drain plug
EVERY 400 HOURS
1. Adjusting front axle pivot [4WD]
If the front axle pivot pin adjustment is not correct, front
wheel vibration can occur causing vibration in the
steering wheel.
Adjusting procedure
1. Loosen the lock nut, and tighten the adjusting screw
so that the oscillating load is 50 to 100 N (5.1 to
10.2 kgf, 11.2 to 22.5 lbf).
EVERY 200 HOURS PERIODIC SERVICE
B2401DT, B2401DTWO, B2401DTN
75