41
TIRES, WHEELS AND BALLAST
B
Rear Wheels
Rear tread width can be adjusted as shown with the standard equipped tires.
To change the tread width
1. Loosen the nut of cotter pin bolt.
2. Remove the snap pin and wheel hub pin.
3. Change the tread to the desired position.
4. Re-set the wheel hub pin, snap pin and cotter pin bolt.
A
Insert the bolt from the indented side of the cotter (A)
as shown.
Tire
7-16 Farm
8-16 Farm
9.5-16 Farm
212/80D-15 Turf
29 x 12.00-15 Turf
857 mm to
1035 mm
935 mm to
1035 mm
969 mm to
1069 mm
935 mm to
1035 mm
985 mm
Tread
A
Always attach tires as shown in the drawings.
A
If not attached as illustrated, transmission parts may be damaged.
A
When re-fitting or adjusting a wheel, tighten the bolts to the following torques then recheck after driving the tractor
200 m (200 yards) and 10 times of shuttle movement by 5 m (5 yards), and thereafter according to service interval.
(See "MAINTENANCE" section.)
(1) Nut
(2) Spring washer
(3) Bolt
(4) Wheel hub pin
(5) Snap pin
(6) Hub
(A) 123 to 147N-m
(12.6 to 15.0 kgf-m)
(B) 108 to 125 N-m
(11.0 to 12.8 kgf-m)
(1) Cotter (A)
(2) Cotter (B)
(3) Nut
(4) Spring washer
(5) Hub
(6) Bolt
