FRONT AXLE
B1220, B1620, B1820, WSM
6-S7
(EU)
Front Gear Case
1. Remove the knuckle arm (Left side only).
2. Remove the axle flange (2).
3. Remove the external snap ring (3).
4. Remove the bevel gear case (4) from front gear case (1).
5. Remove the oil seal (5).
6. Remove the ball bearing 1 (6).
7. Remove the internal snap ring (7) and remove the ball bearing
2 (8).
8. Remove the bevel gear shaft (9) with ball bearing.
(When reassembling)
1. Apply liquid gasket (Three Bond 1206D or equivalent) to joint
face of the axle flange (2) and front gear case (1) after eliminate
the water, oil and stuck liquid gasket.
2. Tighten the axle flange mounting screws and nuts diagonally in
several steps.
3. Install the oil seal (5) of bevel gear case, noting its direction as
shown in the figure.
9Y1210272FAS0011US0
Tightening torque
Knuckle arm mounting
screw
78 to 90 N·m
7.9 to 9.2 kgf·m
58 to 66 lbf·ft
Axle flange mounting screw
48 to 56 N·m
4.9 to 5.7 kgf·m
36 to 41 lbf·ft
(1) Front Gear Case
(2) Axle Flange
(3) External Snap Ring
(4) Bevel Gear Case
(5) Oil Seal
(6) Ball Bearing 1
(7) Internal Snap Ring
(8) Ball Bearing 2
(9) Bevel Gear Shaft
KiSC issued 07, 2011 A
Summary of Contents for B1220
