Kubota AP-SR2672, Operator'S Manual

Page: 18 / 36

14
Section 1: Assembly & Set-up
AP-SR2672, & AP-SR2690 for Skid Steer Powered Rakes 321-004MK 4/10/19
Table of Contents
Switch & Wire Harness For Kubota CTL Skid Steer
Figure 1-7
Control Harness With Deutsch 2 Pin Plug
Refer to Figure 1-7:
323-096A . . .SWITCH & WIRE HARNESS DTP PLUG
This switch and wire harness is designed for attaching
the Powered Rake to a Kubota CTL when a 14 pin
Deutsch plug is not available and 2 pin Deutsch plug
located behind the driver’s seat is available. The 2 push
button control switch (#10) can be placed approximately 9
ft. from the solenoid valve.
Refer to Figure 1-8:
1. Attach Deutsch 2 pin plug (#9) to the Kubota CTL
male plug (#11) located behind the driver’s seat.
Refer to Figure 1-9:
2. Fuse (#12) is supplied by customer. Install 10 amp
fuse (#12) in Kubota’s fuse box slot #17 labeled
“Electrical Outlet-2”.
Refer to Figure 1-7:
3. The push button control switch (#10) is mounted
using the magnets on its back side. Locate and
mount this switch in a convenient easy to reach
location.
4. Connect power cord (#8) to control switch wire (#7).
5. Connect green & black wire connector (#1) to top
solenoid wire (#2).
6. Connect red and white wire connector (#3) to bottom
solenoid wire (#4).
7. Skip to “Operational Check” on this page.
37139
Red Wire
Green Wire
Solenoid Valve
Kubota Power Connection (Located Behind Drive Seat)
Figure 1-8
Installation of 10 amp Fuse
Figure 1-9
37389
9
11
37390
12