Kubota AP-SA35, Operator'S Manual

Page: 15 / 34

Section 1: Assembly & Set-up
Table of Contents
4/9/19 AP-SA35 Hydraulic Post Hole Digger 317-093MK
11
Spring Hose Loop Assembly
Figure 1-4
Spring Hose Loop Assembly
Refer to Figure 1-4:
1. Attach spring hose loop (#5) to hitch plate (#1) with
3/8"-16 x 1" GR5 cap screw (#2), flat washer (#4),
and hex locknut (#3).
2. Torque nut to the correct torque.
Hose Hook-up
WARNING
!
To avoid serious injury or death:
•
Make sure hydraulic hoses are properly routed without
twists to prevent becoming stretched, pinched, or kinked. A
damaged hose can burst and leak hydraulic fluid.
•
This attachment has a 3500 psi maximum hydraulic
pressure rating. Make sure your powered machine’s
hydraulic pressure to this attachment does not exceed 3500
psi. Exceeding this rating can result in equipment damage,
serious injury, or death.
•
Hydraulic fluid under high pressure can penetrate the skin
and/or eyes causing a serious injury. Wear protective gloves
and safety glasses or goggles when working with hydraulic
systems. Use a piece of cardboard or wood rather than
hands when searching for leaks. A doctor familiar with this
type of injury must treat the injury within a few hours or
gangrene may result. DO NOT DELAY.
37743
NOTE: Spring Hose Loop may not be used on some
Skid Steer hook-ups. For additional information, see
step 1 under
“Hose Hook-up” on page 11.
Option 1 Hose Routing
Figure 1-5
Option 2 Hose Routing
Figure 1-6
1. Route hydraulic hoses through the most convenient
path to access your power equipment couplers. See
Options 1 & 2 below. Use Option 2 if attaching to a
Kubota SVL skid steer.
Option 1 - Refer to Figure 1-5:
Thread hydraulic hoses up through hose bracket
and then through spring hose loop as shown.
Option 2 - Refer to Figure 1-6:
a. If mounted, remove spring hose loop from hitch
plate to facilitate accessing Skid Steer cab.
b. Thread hydraulic hoses down through hose
bracket and out through open end of hitch plate.
Male Coupler Female Coupler
Spring Hose
Loop
Top Angle
Bar
Hose Bracket
Zip Ties
Right Port
Left Port
19232
33083
Male Coupler
Hose Bracket
Zip Ties
Female Coupler
Open End Of Hitch Plate
(Typical Both Ends Of Hitch Plate)
If Mounted,
Remove Spring
Hose Loop
Right Port
Left Port