KTR-STOP
®
XS-xx A-xx-xx
Operating/Assembly instructions
KTR-N
Sheet:
Edition:
45126 EN
8 of 22
1
Please observe protection
note ISO 16016.
Drawn:
2020-04-09 Shg/Wie
Replacing:
---
Verified:
2020-08-11 Shg
Replaced by:
Subassembly 2: Pad retraction sets
Compo-
nent
Quantity
Description
Illustration 5: Pad retraction set
2.1
1
Pin
2.2
1
Pressure spring
2.3
1
Disk
To ensure the full braking power, the preparations for assembly need to be carefully per-
formed.
•
The connection plate or the stand for the brake as well as the brake disk have to be inspected for dimensional
accuracy. For that purpose investigate the connection dimensions, connection surfaces and tolerances as
specified in the drawing (see illustrations 1 and 2 and table 3).
•
Clean and degrease the brake disk and mounting surfaces. Dirt can easily be removed by means of solvents.
The connection between connection surface and brake is defined as frictional connection.
Any residues of oil, dirt and corrosion protection reduce the coefficient of friction. As a re-
sult the operation of the brake and the full braking power are no longer ensured.
!
Ob
serve the manufacturer’s instructions regarding the use of solvents.
KTR supplies brake pads free from asbestos and lead only.
If requested, we will provide you with the respective certificates.
The brake pads are each adapted to the application and delivered accordingly.
They can be distinguished as follows:
•
organic material
•
powder metal
!
Brake pads are highly sensitive to grease and oil which means that they cannot be cleaned.
Brake pads with such dirt need to be replaced and disposed of.
We recommend to store the brake pads in their package as long as possible to protect them
from any kind of dirt.
!
Brake pads which have worn off to the wear limit have to be replaced immediately. Make
sure to replace by original parts only.
4
Assembly
4.1 Components of the brake
4.2 Preparation of assembly
4.3 Brake pads
