3 WORK
6
3.1
Removing the start number plate
M01681-10
–
Remove screw
1
.
–
Unhook the start number plate from the brake line and remove
it.
3.2
Adjusting the handlebar position
Warning
Danger of accidents
A repaired handlebar poses a safety risk.
If the handlebar is bent or straightened, the material becomes fatigued. The handlebar may break as a
result.
–
Change the handlebar if the handlebar is damaged or bent.
M01659-11
–
Remove screws
1
. Take off the handlebar clamps. Remove
the handlebar and lay it to one side.
Info
Cover the components to protect them against damage.
Do not kink the cables and lines.
–
Remove screws
2
. Take off handlebar supports.
–
Place handlebar supports in required position. Mount and
tighten screws
2
.
Guideline
Screw, handle-
bar support
M10
40 Nm (29.5 lbf ft)
Loctite
®
243™
Mount the left and right handlebar supports in the same
position.
–
Position the handlebar.
Info
Make sure the cables and wiring are positioned cor-
rectly.
–
Position the handlebar clamps. Mount screws
1
and tighten
evenly.
Guideline
Screw, handlebar
clamp
M8
20 Nm (14.8 lbf ft)
Info
Make sure the installed gaps are even.
