KTM Freeride 350, Owner'S Manual

Page: 47 / 113

SERVICE WORK ON THE CHASSIS
45
10.19
Locking the seat
B01022-10
–
Fold down the seat and push it down.
The seat engages with an audible click.
–
Finally, check that the seat is correctly locked.
10.20
Removing the air filter housing
x
Note
Engine failure Unfiltered intake air has a negative effect on the service life of the engine.
–
Never ride the vehicle without an air filter since dust and dirt can get into the engine and result in increased wear.
Preliminary work
–
Fold the seat up. ( p. 44)
B01060-10
Main work
–
Pull off air filter housing
1
and pre-filter
2
toward the top.
10.21
Installing the air filter housing
x
B01061-10
Main work
–
Position pre-filter
1
on the air filter housing.
Note
Engine failure If the pre-filter is incorrectly mounted or not mounted at all, the air-
fuel mixture will be different. This has a negative effect on the service life of the
engine.
–
Make sure the pre-filter is seated correctly.
–
Attach air filter housing
2
to the inlet sleeve together with the mounted pre-filter.
Info
If the air filter housing is not mounted correctly, dust and dirt may enter the
engine and cause damage.
Subsequent work
–
Lock the seat. ( p. 45)
10.22
Removing the air filter
x
Note
Engine failure Unfiltered intake air has a negative effect on the service life of the engine.
–
Never ride the vehicle without an air filter since dust and dirt can get into the engine and result in increased wear.
Warning
Environmental hazard Hazardous substances cause environmental damage.
–
Oil, grease, filters, fuel, cleaners, brake fluid, etc., should be disposed of as stipulated in applicable regulations.
Preliminary work
–
Fold the seat up. ( p. 44)