KTM Freeride 350 AU, Owner'S Manual

Page: 82 / 116

15 ELECTRICAL SYSTEM
80
15.9 Changing the turn signal bulb
Note
Damage to reflector Reduced brightness.
–
Grease on the lamp will evaporate due to the heat and be deposited on the reflector. Clean the lamp and keep it free of grease
before mounting.
M00527-10
Main work
–
Remove the screw on the rear of the turn signal housing.
–
Carefully remove diffuser

.
–
Lightly squeeze together the orange cap

in the area of the holding lugs and take
it off.
–
Press the turn signal bulb carefully into the socket, turn it counterclockwise by
about 30°, and take it out of the socket.
Info
Do not touch the reflector with your fingers, and keep it free from grease.
–
Press the new turn signal bulb carefully into the socket and turn it clockwise until
it stops.
Turn signal (R10W/socket BA15s) ( p. 101)
–
Mount the orange cap.
–
Position the diffuser.
–
Insert the screw and first turn it counterclockwise until it engages in the thread.
Tighten the screw slightly.
Finishing work
–
Check that the turn signal system is functioning properly.
15.10 Checking the headlight setting
0 0 A A
0 0 B B
400726-10
–
Position the vehicle upright on a horizontal surface in front of a light wall and make
a mark at the height of the center of the low beam headlight.
–
Make another mark at a distance  under the first mark.
Guideline
Distance

5 cm (2 in)
–
Position the vehicle vertically at a distance  away from the wall.
Guideline
Distance

5 m (16 ft)
–
The rider now sits down on the motorcycle.
–
Switch on the low beam.
–
Check the headlight setting.
The boundary between light and dark must be exactly on the lower mark for a
motorcycle with driver.
» If the boundary between light and dark does not meet specifications:
–
Adjust the headlight range. ( p. 80)
15.11 Adjusting the headlight range
Preparatory work
–
Check the headlight setting. ( p. 80)