KTM Freeride 250 F 2018, Owner'S Manual

Page: 78 / 157

12 SERVICE WORK ON THE CHASSIS
76
F01191-10
Main work
–
Loosen nut 1 .
–
Loosen nuts
2
.
–
Adjust the chain tension by turning adjusting screws
3
on
the left and right.
Guideline
Chain tension 36 … 40 mm (1.42 …
1.57 in)
Turn adjusting screws
3
on the left and right so that the
markings on the left and right chain adjusters are in the
same position relative to reference marks
A . The rear
wheel is then correctly aligned.
–
Tighten nuts
2
.
–
Make sure that chain adjusters
4
are fitted correctly on
adjusting screws
3
.
–
Tighten nut
1
.
Guideline
Nut, rear wheel spin-
dle M20x1.5 80 Nm (59 lbf ft)
Info
The wide adjustment range of the chain adjusters
enables different secondary ratios with the same chain
length.
Chain adjusters
4
can be turned by 180°.
Finishing work
–
Remove the motorcycle from the lift stand. ( p. 53)
12.36 Checking the chain, rear sprocket, engine sprocket and chain guide
Preparatory work
–
Raise the motorcycle with a lift stand. ( p. 53)
400227-01
Main work
–
Shift gear to neutral.
–
Check the rear sprocket and engine sprocket for wear.
» If the rear sprocket and engine sprocket are worn:
–
Change the drivetrain kit.
Info
The engine sprocket, rear sprocket and chain
should always be replaced together.