KTM F9903SE, Setup Instructions

Page: 8 / 25

2 SETUP
6
S03373-10
(Super Duke GT US)
–
Bond the reflectors on the right and left side of the reflec-
tor holder.
–
Mount the reflector holder on license plate holder
8
.
Guideline
Remaining screws,
chassis M6 10 Nm (7.4 lbf ft)
S03377-01
–
Remove the cable ties of the rider footrests.
–
Carefully loosen and remove the tension belt from the frame.
Info
An assistant prevents the motorcycle from falling over.
–
Carefully loosen and remove the tension belts around the fork
legs.
The vehicle is released at the front.
–
Together with an assistant, take the vehicle off the pallet.
–
Remove the radiator shield.
E00273-01
–
Remove passenger seat. ( p. 8)
Info
The Race-on key is located in the left storage compart-
ment.
–
Remove spare key and
KEYCODECARD
and keep in a safe place
for the handover.
–
Secure tool set with the rubber strap.
S03213-11
–
Place on the vehicle and adjust both rear mirrors in a horizon-
tal position.
–
Check minimum spacing
C
between the mirror bar and wind-
shield after the handlebar has been driven in fully.
Guideline
Minimum spacing
C
between the mirror bar and
windshield
9 mm (0.35 in)
» If the spacing
C
between the mirror bar and windshield is
below the minimum:
–
Adjust the steering angle. ( p. 10)
–
Make sure that there is sufficient space between the controls
and fuel tank when the handlebar has been driven in fully after
completing the work.