Setting options in the display
KILOMETERS OR MILES.
You can have the speed and distance shown in kilometers or miles in the display. The dis-
play can be adapted to the respective country on long-distance trips.
To switch from kilometers to miles, switch on the ignition and press the MODE
[1]
button
for approx. 10 seconds. The
km/h
display will switch to
mph
. The speed and the stored dis-
tances will be converted and displayed in miles.
To return to kilometers, proceed as described above.
SET CLOCK
Switch on the ignition and change to the CLOCK mode.
Simultaneously press MODE
[1]
and SET
[2]
. The numbers on the clock will start to blink.
Use the MODE button to set the hours and the SET button to set the minutes.
The press the MODE and SET buttons simultaneously.
NOTE:
0:00
will be displayed if the clock is not supplied with electricity. This can be caused by a
defective fuse or a fault in the board electric system (see Troubleshooting).
TRIP 1
The trip meter 1 runs continuously and counts up to 999.9. It can be used to measure the
length of a certain route on a trip or the distance between two refueling stops.
To return the trip meter 1 to zero, switch on the ignition, change to the TRIP 1 mode and
press the SET button
[2]
.
OPERATION INSTRUMENTS
»
10
10 sec
2
2
1
1
Summary of Contents for 950 SUPERMOTO R
Page 1: ...950 SUPERMOTO ART NR 3 211 82EN OWNER S MANUAL 2006 ...
Page 87: ...86 ...
Page 88: ...87 ...
Page 89: ...88 ...
