KTM 690 Enduro R AUS 2013, Setup Instruction

Page: 6 / 17

2 SETUP
4
100309-01
–
Mount and tighten the rear mirror adapter and rear mirror on both sides.
–
Exactly position all controls on the handlebar. Tighten all screws.
–
Fit and tighten the M8 screw of the right hand guard.
100308-01
–
Mount the footrests with the springs and bolts. Secure the bolts using the washers
and pins.
Pliers for footrest spring (58429083000)
–
Remove the protective plastic.
–
Carefully loosen and remove the tensioning belt over the link fork.
Info
An assistant prevents the motorcycle from falling over.
–
Carefully loosen and remove the tensioning belts around the lower triple clamp.
The vehicle is released at the front.
–
Together with an assistant, take the vehicle off the palette.
B00247-12
–
Recharge the battery. ( p. 6)
–
Connect plug
1
to the starter relay.
B00248-10
–
Remove the rear fairing. ( p. 9)
–
Four markings
2
can be seen on the underside of the rear fairing. At these posi-
tions, drill holes in three steps of the prescribed size.
Guideline
Hole diameter for grab handles 14.50 mm (0.5709 in)
B00249-10
–
Remove screws
3
.
–
Fit the rear fairing. ( p. 9)
700217-01
–
Mount the reflector.