KTM 690 Enduro R AUS 2013, Setup Instruction

Page: 11 / 17

3 WORK
9
3.8 Removing rear fairing
Preparatory work
–
Remove the seat. ( p. 6)
100311-10
Main work
–
Remove screws
1
.
100314-10
–
Remove screws
2
.
–
Open the filler cap. ( p. 8)
–
Take off the rear fairing.
–
Close the filler cap. ( p. 8)
3.9 Fitting rear fairing
100315-10
–
Position the license plate holder and cable harness.
–
Open the filler cap. ( p. 8)
–
Position the rear fairing and grab handles
1
as shown in the figure. Fit and slightly
tighten the screws of the grab handles.
–
Close the filler cap. ( p. 8)
–
Fit and tighten the screws on the rear fairing.
Guideline
Remaining screws, chassis M6 10 Nm (7.4 lbf ft)
100314-10
–
Mount and tighten screws
2
.
–
Tighten the screws of the grab handles.
Guideline
Screw, handrail M8 20 Nm
(14.8 lbf ft)
–
Mount the seat. ( p. 6)
3.10 Fitting the rear footrest bracket
Info
The operations are the same for the left and right sides.
100316-10
–
Position the footrest bracket
1
. Mount and tighten screws
2
.
Guideline
Screw, rear footrest bracket M8x16 25 Nm
(18.4 lbf ft)