KTM 690 Duke AU/GB 2014, Setup Instructions

Page: 8 / 15

3 WORK
6
–
Disconnect the negative cable of the battery to avoid damage to the motorcycle's
electronics.
B00964-10
Main work
–
Connect the battery charger to the battery. Switch on the battery charger.
Battery charger (58429074000)
You can also use the battery charger to test the rest potential and start potential of
the battery, and to test the alternator. With this device, you cannot overcharge the
battery.
Info
Never remove lid

.
–
Switch off the charger after charging. Disconnect the battery.
Guideline
The charge current, charge voltage, and charge time must not be exceeded.
Charge the battery regularly when the
motorcycle is not in use
3 months
Finishing work
–
Mount the passenger seat. ( p. 5)
–
Set the clock. ( p. 7)
3.4 Installing the battery
B00963-11
Main work
–
Position the battery in the battery holder.
Info
The terminals of the battery must face in the direction of travel.
–
Attach rubber band

.
–
Reconnect the positive cable

of the battery.
Guideline
Screw, battery terminal M6 2 Nm (1.5 lbf ft)
–
Position positive terminal cover  .
B00962-11
–
Connect the negative cable  of the battery.
Guideline
Screw, battery terminal M6 2 Nm (1.5 lbf ft)
Finishing work
–
Mount the passenger seat. ( p. 5)
–
Set the clock. ( p. 7)