ENGLISH
30
Headlight range adjustment *
The range by the low beam
1
and the high beam
2
can be adjusted by
means of the screws
3
.
These screws
3
are accessible when the headlight mask is opened.
Turn the screws clockwise to reduce the distance lighted.
Turn the screws counterclockwise to increase the distance lighted.
Headlight - replacing the bulbs *
Open the headlight mask.
Take off the cable plug
4
.
Turn the bulb
5
counterclockwise all the way to the stop, then take it out
of the headlight.
The glass bulb and the bulb socket are one single unit. Do not attempt to
pull the bulb out of the socket. The lamp is a special bulb (Type HB3) which
is not available everywhere. Therefore, always make sure to have a spare
lamp with you.
Insert the new bulb into the headlight, avoiding to touch the glass of the
bulb with bare fingers.
!
CAUTION
!
N
EVER TOUCH THE GLASS OF THE BULB WITH YOUR FINGERS
. T
HE GLASS OF THE BULB
MUST REMAIN ABSOLUTELY FREE FROM GREASE
. H
EAT WILL OTHERWISE CAUSE THE
GREASE TO EVAPORATE AND SETTLE DOWN ON THE REFLECTOR
.
Reconnect the cable plug.
Start the engine and check the headlight for proper functioning.
Close the headlight mask.
Parking light - replacing the bulb *
The parking light is located in the upper headlight.
Open the headlight mask.
Pull the bulb socket
6
upward and out of the headlight.
Pull the old bulb out of the bulb socket and insert a new bulb.
!
CAUTION
!
N
EVER TOUCH THE GLASS OF THE BULB WITH YOUR FINGERS
. T
HE GLASS OF THE BULB
MUST REMAIN ABSOLUTELY FREE FROM GREASE
. H
EAT WILL OTHERWISE CAUSE THE
GREASE TO EVAPORATE AND SETTLE DOWN ON THE REFLECTOR
.
Check if the lamp works properly.
Reassemble the unit, reversing the worksteps indicated above.
Flasher - replacing the bulbs
Remove screw
7
and remove the lens.
Depress the bulb, turn it to the left and pull it out of the bulb socket.
To reassemble the flasher light, reverse the above-described sequence.
1
2
3
3
3
3
4
4
5
7
6
