ENGLISH
How to change the handlebar position
The handlebar position can be readjusted by 37 mm. Thus, you can put the
handlebar to the position that is the most convenient for you.
The upper triple clamp
1
includes 3 bores arranged at a distance of 15 mm
(0,6 in) from one another. The bores at the handlebar support
2
are offset
from the center by 3.5 mm. Accordingly, you can mount the handlebar in
6 different positions.
For this purpose, remove screws
3
of the handlebar clamps and screws
4
of the handlebar support. Position handlebar support, apply Loctite 243 and
tighten screws
4
to 40 Nm (30 ft.lb). Mount handlebar and handlebar
clamps, and tighten screws
3
to 20 Nm (15 ft.lb). The gap between hand-
lebar support and handlebar clamps is to be of equal size in the front and in
the rear.
STANDARD POSITION:
The middle hole in the triple clamp and the offset in the handlebar support
facing the front.
Changing the height of the tail end
The height of the tail end can be adjusted by 48 mm to adapt the handling
to the race course. The shock absorber is fastened at the top in a eccentric
bushing.
Before changing the height of the tail end, measure the original position. To
measure, jack up the motorcycle, measure and write down the distance bet-
ween the swing arm and the end of the subframe.
"HIGH TAIL END" = better handling in curves
"LOW TAIL END"= better driving stability on straight stretches
more traction on the rear wheel when accelerating
more braking stability.
To change the height of the tail end, loosen the clamping screws
5
. Place a
19 mm socket wrench on the HH screw
6
and turn the eccentric accor-
dingly. Do not turn the eccentric more than 90 ° up or 90 ° down from the
standard position. The adjustment range is ± 24 mm on the rear wheel.
Tighten the clamping screws to 25 Nm.
STANDARD POSITION.
The holes in the left eccentric must be
aligned with the slot in the clamping
(see illustration).
20
LOCTITE 243
1
2
3
4
5
5
6