9
- Insert wafers
with the number 1 into the chambers
,
and
.
- Insert the key and check whether the wafers with the
number 1
fi
t.
- Replace wafers that do not
fi
t with wafers with the right number.
NOTE
The wafers should be aligned
fl
ush with the locking cylinder. The num-
ber of visible grooves indicates which wafer needs to be used. This
example shows a cylinder in which three wafers with
number 1
have
been installed. Two grooves are visible on each of the two protruding
wafers. This means that wafers with
number 3
need to be installed.
It is advisable to note down which numbers the matching wafers have
so that the other locking cylinders can be assembled in the same
manner.
- Repeat the steps for the slots
,
and
until the
fi
rst six slots
are occupied with the matching wafers.
- Insert spring
for the snap-in plate and then the snap-in plate
into slot
.
NOTE
Slots
and
remain empty.
- Mount O-ring
.
- Position locking cylinder as shown in the
fi
gure and insert with the
aid of the key (catch must face upward).
Snap-in plate
(:
engages.
ENGLISH