KTM 450 XC-W USA, Setup Instructions

Page: 9 / 31

2 SETUP
7
C00117-01
(500 EXC US)
–
Mount the license plate holder with the license plate lamp, turn signals, and
reflector.
–
Connect the electrical components.
–
Connect the connector of the left turn signal with the connector that is marked
red.
–
Connect the connector of the right turn signal with the connector that is marked
green.
101393-12
Warning
Risk of injury Battery acid and battery gases cause serious chemical burns.
–
Keep batteries out of the reach of children.
–
Wear suitable protective clothing and goggles.
–
Avoid contact with battery acid and battery gases.
–
Keep sparks and open flames away from the battery. Only charge in
well-ventilated rooms.
–
In the event of skin contact, rinse with large amounts of water. If battery
acid gets in the eyes, rinse with water for at least 15 minutes and con-
tact a physician.
–
Fill the battery.
Info
Read the notes in the battery package.
–
Charge the battery. ( p. 16)
–
Install the battery. ( p. 15)
–
Unpack and mount the KTM PowerParts included in the delivery (optional).
Info
Read the accompanying KTM PowerParts fitting instructions.
–
Apply the label included in the delivery (optional).
–
Set kilometers or miles. ( p. 23)
–
Set the speedometer functions. ( p. 24)
–
Set the clock. ( p. 24)
–
Refuel. ( p. 22)
–
Position all controls in their exact positions on the handlebar. Tighten all screws.
–
Prepare the vehicle according to the specifications in the KTM Dealer.net for han-
dover to the customer.