11 SERVICE WORK ON THE CHASSIS
62
F01837-11
–
Mount and tighten screw
7
.
Guideline
Screw, top
steering stem
M8
20 Nm (14.8 lbf ft)
Loctite
®
243™
F01838-10
–
Using a plastic hammer, tap lightly on the upper triple
clamp to avoid stresses.
–
Tighten screws
8
.
Guideline
Screw, top triple
clamp
M8
17 Nm
(12.5 lbf ft)
–
Secure the wiring harness with cable holder
9
on the
left.
K01014-12
–
Position the brake caliper. Mount and tighten screws
bk
.
Guideline
Screw, front
brake caliper
M8
25 Nm (18.4 lbf ft)
Loctite
®
243™
–
Position the brake line and the clamp. Mount and tighten
screws
bl
.
Finishing work
–
Install front fender. (
–
Mount the handlebar cushion.
–
Install the start number plate. (
–
Install the front wheel.
–
Check that the wiring harness, throttle cables, and brake and
clutch lines can move freely and are routed correctly.
–
Check steering head bearing play. (
–
Remove the motorcycle from the lift stand. (
11.13
Checking steering head bearing play
Warning
Danger of accidents
Incorrect steering head bearing play impairs the handling characteristic and dam-
ages components.
–
Correct incorrect steering head bearing play immediately. (Your authorized KTM workshop will be glad
to help.)
Summary of Contents for 450 SX-F 2019
Page 2: ......