KTM 250 SX-F, Setup Instructions

Page: 7 / 19

2 SETUP
5
K00377-10
–
Remove screws

. Take off the handlebar clamps. Remove the handlebar and lay
it to one side.
Info
Cover the components to protect them against damage.
Do not kink the cables and lines.
–
Remove screws

. Remove handlebar support

.
–
Position rubber bushings  and push through nuts  from below.
–
Position the handlebar.
Info
Make sure the cables and wiring are positioned correctly.
–
Position the handlebar clamps. Mount screws

. Screw the handlebar clamps so
that both parts touch at the front and tighten all of the screws.
Guideline
Screw, handlebar clamp M8 20 Nm
(14.8 lbf ft)
M01067-01
–
Position the controls on the right half of the handlebar.
Info
The routing of the cables can be seen in the figure.
M01068-01
–
Position the controls on the left half of the handlebar.
Info
The figure shows how to route the clutch line and wiring harness.
–
Install the front fender. ( p. 7)
–
Install the front wheel. ( p. 6)
–
Mount the fuel tank breather correctly.
M01069-01
–
Mount the handlebar cushion.
–
Install the start number plate. ( p. 7)
–
Install the footrests. ( p. 8)
–
Recharge the battery. ( p. 10)
–
Install the battery. ( p. 9)
–
Unpack and mount the KTM PowerParts included in the delivery (optional).
Info
Read the accompanying KTM PowerParts fitting instructions.
–
Apply the label included in the delivery (optional).
–
Refuel. ( p. 12)
–
Position all controls in their exact positions on the handlebar. Tighten all screws.
Guideline
Screw, handle bar fixed
grip, left M4 5 Nm
(3.7 lbf ft) Loctite ® 243™
–
Prepare the vehicle according to the specifications in the
KTM Dealer.net
for han-
dover to the customer.