2
SETUP
5
C00540-10
(All XCF-W models)
–
Connect pull switch
with the yellow and white cables.
–
Position the speedometer and connector board. Mount and tighten screws.
Guideline
Remaining screws, chassis
M6
10 Nm
(7.4 lbf ft)
C00523-10
–
Position the controls on the right half of the handlebar.
Info
The routing of the cables can be seen in the figure.
C00524-10
–
Position the controls on the left half of the handlebar.
Info
The figure shows how to route the clutch line and wiring harness.
B01749-01
(All EXC
‑
F models)
–
Remove the fuel tank.
–
Position the turn signal wiring harness against the main wiring harness and
secure with cable binders.
B01750-01
–
Disconnect the plug-in connection from the main wiring harness and con-
nect the turn signal wiring harness.
–
Install the fuel tank.
M00149-01
–
Position the turn signal on each side and mount and tighten nuts.
–
Connect plug-in connection of the right turn signal using the black and
brown cable colors.
–
Connect plug-in connection of the left turn signal using the violet and
brown cable colors.
