WORK
9
100314-10
–
Remove screws
.
–
Open the filler cap. (
–
Take off the rear fairing.
–
Close the filler cap. (
3.9
Fitting rear fairing
100315-10
–
Position the license plate holder and cable harness.
–
Open the filler cap. (
–
Position the rear fairing and grab handles
as shown in the figure. Fit and slightly
tighten the screws of the grab handles.
–
Close the filler cap. (
–
Fit and tighten the screws on the rear fairing.
Guideline
Remaining screws, chassis
M6
10 Nm (7.4 lbf ft)
100314-10
–
Mount and tighten screws
.
–
Tighten the screws of the grab handles.
Guideline
Screw, handrail
M8
20 Nm
(14.8 lbf ft)
–
Mount the seat. (
3.10
Fitting the rear footrest bracket
Info
The operations are the same for the left and right sides.
100316-10
–
Position the footrest bracket
. Mount and tighten screws
.
Guideline
Screw, rear footrest bracket
M8x16
25 Nm
(18.4 lbf ft)
3.11
Fitting heel protector
Info
The operations are the same for the left and right sides.
