WORK
6
3.1
Removing the seat
100230-10
–
Pull on strap
and raise the rear of the seat at the same time.
–
Pull back the seat and lift it off.
3.2
Mounting the seat
100276-10
–
Hook slot
of the seat onto screw
, press the rear downward and at the same
time push it forward.
–
Push locking pin
into lock housing
and push the back of the seat down until
the locking pin locks in place with an audible click.
–
Finally, check that the seat is correctly mounted.
3.3
Removing the battery
Warning
Risk of injury
Battery acid and battery gases cause serious cauterization.
–
Keep batteries out of the reach of children.
–
Wear suitable protective clothing and goggles.
–
Avoid contact with battery acid and battery gases.
–
Keep the battery away from sparks or open fire. Charge only in well ventilated rooms.
–
In the event of skin contact, rinse with large amounts of water. If battery acid gets in the eyes, rinse with water for at least
15 minutes and contact a doctor.
–
Switch off all power consumers and switch off the engine.
–
Remove the seat. (
100277-10
–
Disconnect the negative (minus) cable of the battery.
–
Pull off the plug connector
upwards.
–
Remove screws
.
–
Pull the retaining bracket
of the battery forward and remove it.
–
Take off the positive pole cover
.
–
Disconnect the positive (plus) cable of the battery.
–
Push the wiring harness to the side and pull the battery out of the battery rack.
Info
Never operate the motorcycle with a discharged battery or without a battery.
In both cases, electrical components and safety devices can be damaged.
The vehicle is therefore no longer roadworthy.
