ENGLISH
11
OPERATION INSTRUMENTS
»
Combination switch
The light switch has 3 switch positions.
[A]
= Light off
[B]
= Low beam light
[C]
= High beam light
The red short circuit button
[1]
serves to switch off the engine. Leave the
switch pressed, until the engine stops. With the button
[2]
the horn will sound.
Flasher switch
The flasher switch is a separate unit and is mounted on the left portion of the
handlebar.
The wire harness is designed in a way that whenever you want to use your
bike in competition, you can dismount the entire turn indicator system with-
out affecting the function of the remaining electrical system.
Flasher left
Flasher right
Emergency OFF switch (Australia)
The emergency OFF switch
[3]
is located next to the throttle grip. Primarily
designed as safety or emergency OFF switch, it should normally not be in its
activated state.
In this position, the ignition circuit is shorted; if the engine is running,
it will stall immediately, if it is at standstill, it will not start.
In this position, the ignition circuit is enabled; the engine should start.
Filler cap
To open filler cap:
Turn the filler cap counter-clockwise.
To close filler cap:
Screw on the filler cap clockwise.
Install tank breather hose
[4]
without kinks.
Fuel tap
OFF
In this position the fuel tap is closed. No fuel may flow to the
carburetor.
ON
When using the motorcycle, the rotating handle must be set to the ON
position. Now fuel may flow to carburetor. In this position the tank emp-
ties down to the fuel reserve of approx. 2,5 liters.
RES
The reserve tank, approximately 2,5 liters, cannot be tapped until the
rotating handle is turned to the RES position. Fill the tank as soon as
possible and remember to turn the rotating handle back to the ON posi-
tion so that you will have backup fuel next time, too.
1
2
A
B
C
3
4
