ENGLISH
16
Removing the seat
The quick-release mechanism
1
allows removal of the seat without tools.
Turn the quick-release device approximately 180° anticlockwise, lift the rear
portion of the seat and pull the seat off backwards.
When mounting the seat ensure that the hook
2
engages at the tank.
Cleaning the air filter *
The air filter must be cleaned at intervals depending on the amount of dust
accumulated. To clean the air filter, first remove the seat. Then remove the
two screws
3
, the filter holder and the air filter
4
. The air filter consists of
a foam rubber insert soaked with filter oil.
!
CAUTION
!
D
O NOT CLEAN FOAM FILTER WITH FUEL OR PETROLEUM SINCE THESE WILL DAMAGE THE
FOAM
. KTM
RECOMMENDS THE PRODUCTS MADE BY
PUTOLINE
FOR AIR FILTER
MAINTENANCE
.„A
CTION
C
LEANER
”
FOR CLEANING PURPOSES AND
„A
CTION
F
LUID
”
TO
OIL THE FOAM FILTER
.
Thoroughly wash the foam filter in special cleaning fluid and allow it to dry
well. Only press out the filter, do not wring it out under any circumstances.
Oil the dry foam filter with a high-grade filter oil. Also clean the air filter
box. Check carburetor collar for damage and that it is filled correctly.
Insert the air filter in the opening and fasten it with the filter holder. Then
mount the seat.
Adjusting the throttle cable *
There must always be a 3-5 mm (0.1-0.2 in) play in the throttle cable. To
check this, move back the protective cover
5
on the throttle grip. You must
be able to lift the outer covering of the cable 3-5 mm from the adjusting
screw
7
, until resistance is felt.
To adjust, loosen the counter nut
6
and turn the adjusting screw accor-
dingly. Finally tighten counter nut and slide the protective cover back on.
3-5 mm
3
3
1
2
4
5
6
7
Summary of Contents for 1998 50 SXR Adventure
Page 2: ......
