KTM 125 EXC EU 2014, Setup Instructions

Page: 18 / 27

3 WORK
16
3.17 Refueling
Danger
Fire hazard Fuel is highly flammable.
–
Never refuel the vehicle near open flames or burning cigarettes, and always switch off the engine first. Be careful that no
fuel is spilt, especially on hot vehicle components. Clean up spilt fuel immediately.
–
The fuel in the fuel tank expands when warm and may emerge if overfilled. Follow the instructions on refueling.
Warning
Danger of poisoning Fuel is poisonous and a health hazard.
–
Fuel must not come into contact with the skin, eyes, or clothing. Do not breathe in the fuel vapors. If contact occurs with
the eyes, rinse with water immediately and contact a physician. Immediately clean contaminated areas on the skin with
soap and water. If fuel is swallowed, contact a physician immediately. Change clothing that is contaminated with fuel.
Warning
Environmental hazard Improper handling of fuel is a danger to the environment.
–
Do not allow fuel to get into the ground water, the ground, or the sewage system.
–
Switch off the engine.
–
Open the filler cap. ( p. 15)
400382-10
–
Fill the fuel tank with fuel up to measurement
A
.
Guideline
Measurement of
A
35 mm (1.38 in)
Total fuel tank
capacity, approx.
(EXC EU,
EXC SIX DAYS) 9.5 l
(2.51 US gal) Super unleaded gasoline (95 octane),
mixed with 2-stroke engine oil (1:60)
( p. 22)
Total fuel tank
capacity, approx.
(EXC AUS, XC
‑
W,
XC-W SIX DAYS)
10 l (2.6 US gal) Super unleaded gasoline (95 octane),
mixed with 2-stroke engine oil (1:60)
( p. 22)
2-stroke engine oil ( p. 22)
–
Close the filler cap. ( p. 15)
3.18 125 EXC EU, all 200 models, 250/300 EXC EU, XC-W, EXC AUS
3.18.1 Setting kilometers or miles
Info
If you change the unit of measure, the ODO value is retained and converted accordingly.
The values TR1 , TR2 , A1 , A2 and S1 are cleared when the unit of measure is changed.
Condition
The motorcycle is stationary.
400329-01
–
Press the button briefly and repeatedly until H appears at the bottom right of the
display.
–
Press the button for 3 - 5 seconds.
The Setup menu is displayed and the active functions are shown.
–
Press the button repeatedly until the Km/h / Mph display flashes.
Adjusting Km/h
–
Press the button .
Adjusting Mph
–
Press the button .
–
Press the button for 3 - 5 seconds.
The settings are stored and the Setup menu is closed.