KTM 125 EXC EU 2013, Setup Instructions

Page: 7 / 22

2 SETUP
5
B00904-10
(XC-W)
–
Connect pull switch
5
with the yellow and white cables.
401408-01
(All EXC models)
–
Attach the retaining bracket for the connector, the turn signal bracket with the
turn signal, and the speedometer to the upper triple clamp.
Guideline
Remaining screws, chassis M6 10 Nm
(7.4 lbf ft)
401409-01
(XC-W)
–
Attach the speedometer to the upper triple clamp.
Guideline
Remaining screws, chassis M6 10 Nm
(7.4 lbf ft)
B00096-10
–
Position the controls on the right half of the handlebar.
Info
The routing of the cables can be seen in the figure.
600817-10
–
Position the controls on the left half of the handlebar.
Info
The figure shows how to route the clutch line and wiring harness.
201945-10
(All EXC models)
–
Mount and tighten nuts
6
of the turn signals on both sides.
–
Connect connector
7
of the right turn signal with connector
8
, which is
marked green.
–
Connect connector
9
of the left turn signal with connector
bk
, which is marked
red.
–
Connect the plug of the electric starter button to connector
bl
.