7
- Remove nuts
(4
with the washers.
- Remove both turn signals.
Preassembly of short license plate holder
- Position license plate holder
(included) on the license plate
base
(included).
- Mount screws
with bushings
and nuts
(everything included)
and tighten to 8 Nm.
- Mount both turn signals on license plate holder
.
- Mount and tighten nuts
(4
with the washers.
Properly route wires and ensure that the wires cannot be
kinked or pinched!
Assembly
- Mount lower rear panel
(included).
- Position license plate holder and thread in wire.
- Mount
original screws
(2
and tighten to 12 Nm (Loctite 243).
- Mount original screws
(1
and tighten to 11 Nm.
- Join plug-in connector
for license plate lamp.
- Join plug-in connector
for left turn signal.
- Join plug-in connector
for right turn signal.
ENGLISH
