7.
Configure from Console Port
[ 1 ] Setup Hardware and Software for Configuration
[ Hardware setup ]
Connect from the console port of the Switch to COM port of PC with the
console cable.
[ Software setup ]
1. PC is running MS Windows.
2. Start -> Program -> Accessory -> Terminal. Execute "Hypertrm"
program. If you can not find the Terminal program, please install it
from your MS Windows installation disk.
3. If the connection file has been created, cancel the new connection
request and open the connection file. If the connection file has not been
created, create a new connection named "SW16" -> Select COM port of
PC -> Set COM port parameters as "Baud Rate:
9600
, Data Bits:
8
, Parity
Check:
None
, Stop Bit:
1
, Flow Control:
None
". Then OK.
4. Power on the Switch and the setup console will appear as follow.
5. The default password is "1234" (you can change it in the console
setting). The main screen will appear if the password is correct.
[Notes:] If you can not get the console screen, please reboot the switch or
close the terminal program and start again.
Summary of Contents for KS-316F
Page 4: ...P N 17000083 ...
