11
100 Mbps Connection
For 100BASE-TX Fast Ethernet networks, the adapter supports
Category 5 UTP cabling. To establish a valid 100 Mbps connection,
the cable must be connected to a 100BASE-TX hub.
1. Make sure that the plug on the cable is wired appropriately for
a standard 100BASE-TX adapter.
2. Align the RJ-45 plug on the end of the UTP cable with the
notch on the adapter's connector and insert it into the adapter
connector as shown in Figure 3-5.
Figure 3-6 Connecting 100BASE-TX Cable
Note: The UTP wire pairs and configuration for 100BASE-TX
cable are identical to those for 10BASE-T cable when used with
Category 5 UTP cable. The straight through connection should be
made from the adapter through the cable and connectors to the hub.
Refer to Appendix A.2 for RJ-45 connector pin assignments.
