Operation Instructions
1.
Do not install the camera near electric or magnetic fields.
Install the camera away from TV/radio transmitters, magnets, electric motors, transformers
and audio speakers since the electromagnetic fields generated from these devices may distort
the video image.
2.
Never disassemble the camera beyond the recommendations in this manual nor introduce
materials other than those recommended herein.
Improper disassembly or introduction of corrosive materials may result in equipment failure or
other damage.
3.
Try and avoid facing the camera toward the sun.
In some circumstances, direct sunlight or may cause permanent damage to the sensor and/or
internal circuits.
4.
Keep the power cord away from water and other liquids and never touch the power cord
with wet hands. Touching a wet power cord with hands or touching the power cord with wet
hands may result in electric shock.
5.
Never install the camera in areas exposed to oil, gas or solvents.
Oil, gas or solvents may result in equipment failure, electric shock or, in extreme cases, fire.
6.
Cleaning
Do not touch the surface of the sensor directly with the hands. Use a damp soft cloth to remove
any dirt from the camera body. Use lens tissue or a cotton tipped applicator and ethanol to
clean the sensor and the camera lens. Please do not use complex solvents, corrosive or abrasive
agents for cleaning.
7.
Do not operate the camera beyond the specified temperature, humidity or power source ratings.
Use the camera at temperatures within -20 °C ~ 50 °C (-4 °F ~ 122 °F) and in an IP66 complaint
environment; this device is not rated as submersible. The input power source is 12 V DC/24 V AC.
Please read this manual first for correct installation and operation. This manual should be
retained for future reference. The information in this manual was current when published.
The manufacturer reserves the right to revise and improve its products. All specifications are
therefore subject to change without notice.
2
Precautions
