02
A diameter hole of 0.75” (20mm) with
minimum deepness of 3.5” (89mm) is
to be drilled ensuring it to be straight
and perpendicular to the surface. The
drilled hole must have a uniform
diameter with no trace of peaks and
valleys on the inner wall. Clean the
drilled hole by blowing compressed
air.
Now the eye of the anchor can be
used as anchorage point. Connect
the lanyard with the anchor.
Now the anchor is ready to use.
Put your thumb inside the anchor loop and the first two fingers around the trigger
while placing the anchor. Also until the trigger and spring fully compresses, squeeze
the fingers and thumb together. To lock the anchor, release the trigger after inserting
it in the hole at least 3” (76mm) deep.
SQUEEZE THE TRIGGER
RELEASE THE TRIGGER
6.
INSTRUCTIONS FOR USAGE : AFA930301
The concrete Anchor (AFA930301) may be attached to the structure by pulling on the spring loaded trigger component.
Spoon Orientation
* Best practice for spoon orientation when
0
loaded 90 to hole.
Load
Best
Load
OK
See Spoon Orientation
PROPER LAODING
See Spoon Orientation
Good
Best
Good
0
0
0
90
0
90
HOLE DRILLING REQUIREMENT CHART
(A)” Minimum distance from edge/corner
(B)” Concrete thickness
(B)”
6” (15.3 cm)
12” (30.5 cm)
12” (30.5 cm)
5” (12.7 cm)