KSF CA 400 GL, Manual, Page: 25 / 32

To achieve maximum safety when operating the
machine, ALWAYS comply constantly with the
following rules:
Before each use make sure the functionality of suckers. Pay
particular attention to the rubber disc, it should be smooth, without
defects and should not be cracked.
3. The vacuum suction device should be used only for short periods of
elevation. Where the periods of use extended regularly check the
adhesion of the suction cup. If you do not grip seems more
satisfactory, put it back into place.
4. Do not move loads over people and do not use the cradle as a
support for persons.
5. Only use the vacuum suction cups on smooth surfaces and clean,
dry, without traces of oil or grease.
6. The cups and especially rubber discs should be kept clean and free
of oil or grease.
7. Before each use, check the rubber disc relative to any restrictions on
functionality due a reduced elasticity due to age, wear, improper
maintenance, storage, etc..
8. Hard rubber or damaged with reduced carrying capacity must be
replaced.
1. Only the qualified personnel is allowed to install and use this
equipment for glazing.
2.
K.S.F.
～ ～
23
Maintenance of suction
1. Always keep rubber pads clean and free of oil or grease. Clean
suction pads regularly with spirit or other non-aggressive cleaners.
2. Do not expose rubber pads to sunlight over extended period of time
to preserve their elasticity.
3. If the hand cup dose not function normally, the cup face may be
dirty or the cup may require service.