KSB SuPreme Series, Installation & Operating Manual

Page: 27 / 52

5 Installation at Site
27 of 52
KSB SuPremE
Electrical cable gland on drive
DANGER
Damage to cable sheath
Danger from electric shock!
Damage to the motor!
▷ Adjust the tightening torques to the cable sheath materials.
▷
Do not exceed the tightening torques.
For cable glands made from metal and plastic for establishing a direct connection to
a drive, and for other glands (e.g. reducers), refer to the following table to apply the
correct tightening torques.
Table 21: Bolt/screw sizes and tightening torques for the mechanical components
Shaft
centreline
height
Bearing
cover
Fan
hood
Adapter
plate
Pressure
screw
(material:
PA)
Fastening
of
PumpDrive
2
[mm] Number of bolts/screws 8 3/4 4
71 Thread M5 M5 M5 - M4
Tightening torque [Nm] 6 6 6 - 3
80 Thread M5 M5 M5 - M4
Tightening torque [Nm] 6 6 6 - 3
90 Thread M5 M5 M5 - M4
Tightening torque [Nm] 6 6 6 - 3
100 Thread M6 M5 M5 - M4
Tightening torque [Nm] 10 6 6 - 3
112 Thread M8 M5 M5 - M4
Tightening torque [Nm] 23 6 6 - 3
132 Thread M8 M5 M6 - M6
Tightening torque [Nm] 23 6 10 - 10
160 Thread M10 M6 M8 M40 x 1,5 M6 / M8
Tightening torque [Nm] 46 10 23 8 10 / 23
180 Thread M10 M6 M6 M40 x 1,5 M8
Tightening torque [Nm] 46 10 10 8 23
200 Thread M12 M6 M8 M40 x 1,5 M8
Tightening torque [Nm] 80 10 23 8 23
225 Thread M12 M6 M8 M40 x 1,5 M8
Tightening torque [Nm] 80 10 23 8 23
5.6 Installing and removing output components
▪ Please also note the information about installing output components in the
operating manual of the driven machine (e.g. pump).
▪ To install output components (coupling, pulley, etc.), use the thread on the shaft
end and heat up the components if necessary.
▪
Use an appropriate device for removal.
▪ Do not apply hard impacts (e.g. with a hammer or similar) when installing and
removing.
▪ Observe the maximum permissible radial and axial forces transmitted via the
shaft end to the rolling element bearing and do not exceed them.