Krups XP5220, Manual

Page: 59 / 120

English
53
Before using your espresso machine, clean all the accessories in soapy water and dry them.
If you are not using the Claris cartridge, please refer to the paragraph here below “RINSING OF YOUR
APPLIANCE”.
A. INSTALLING THE CLARIS CARTRIDGE (to be done every time the cartridge is replaced)
If you are using a Claris filter cartridge, please follow the procedure to fill it with water:
n
Screw the Claris filter into the bottom of the water tank.
n
Fill the water tank with water and replace it (fig.2 and 3).
n
Turn the appliance on by pressing the "On / Off" button (fig.4) .
n
Turn the switch to the "steam preheating" position. Once the light stops blinking, turn back the switch
to the "off" position.
n
Repeat this operation 2 more times.
n
To make sure the Claris cartridge is full of water, place a container under the brewing head, turn the
switch to the "coffee" position and make sure some water is running through. If not, repeat the above
procedure.
n
In this manner you can be sure that water is circulating well through the filter cartridge.
IMPORTANT:
This installation procedure must be carried out every time the cartridge is
replaced.
The Claris cartridge needs to be replaced every 2 to 3 months if it is used daily.
B. RINSING YOUR APPLIANCE (to be done on first use and after each cleaning / descaling
operation)
Then rinse the appliance. To do so:
n
Open the lid and remove the water tank using the handle (fig.1) .
n
Fill it with water
(fig. 2)
.
n
Replace the water tank by positioning it firmly, to ensure the water inlet is in place, and close the lid
(fig.3) .
n
Turn the appliance on by pressing the "On / Off" button
(fig.4)
.
n
Insert the filter holder (without ground coffee) in the appliance (fig.7) .
n
Place a container of sufficient volume under the filter holder.
n
Once the appliance has reached the right temperature, the light stops blinking. Turn the switch to the
"coffee" position
(fig.8) and let all the water in the tank run through.
n
If necessary, stop the operation by turning the switch to the "off" position (fig.9) to empty the container
and then resume the operation.
n
Empty the container and unlock the filter holder: press the "OPEN" button on the filter holder and turn
it to the left
(fig.10) .
In order to release all the aromas of the coffee and ensure your complete satisfaction, this machine pre-
infuses each coffee. The pump works for 3 seconds, stops the following 3 seconds and then the cycle
continues until the end of the preparation.
6. MAKING AN ESPRESSO
5. BEFORE FIRST USE